★ BBB A+ Rated ★Online since 1999Serving 40+ Industries(888) WAX-MELTERS | (888) 929-6358Pay an InvoiceEN ES
WaxMelters logoWAXMELTERSThermal Process Equipment 0Cart
Buy NowCart 0Checkout

Melters & Tanks Troubleshooting

Guided troubleshooting

Melters & Tanks

Pick the symptom, try the steps and video from your manual, then tell us if it worked. Still stuck? Send it to our factory team from the same page.

Urgent? Call (888) WAX-MELTERS | (888) 929-6358

See It in Action

Real WaxMelters equipment in production: tap to play

Trusted by

NASA logoFender logoBlue Origin logoYamaha logoJim Beam logoMaker's Mark logo3M logoDuPont logoLockheed Martin logoGeneral Electric logoHoneywell logoSiemens logo

Reviews

  • ★★★★★We purchased our PRIMO Melter and EZ system from Melting & Filling Equipment for our ointment and... Rowena, Herbs From Wales, UNITED KINGDOMRead more
All reviews

Combo setup? Add another unit to this request

01

Melters & Tanks

PRIMO melters, heated holding & dispensing tanks, tilting process kettles

Safety first: Turn the unit off, disconnect it, and allow it to cool completely before inspection, cleaning, valve service, or troubleshooting. Stop immediately for smoke, burning odor, uncontrolled heating, repeated protection-device operation, exposed wiring, or leakage near electrical components.

AWhich equipment?
BWhat is happening?

Melters and tanks troubleshooting

Heat, Sensors and Flow - Start With the Guided Tool

Use the guided troubleshooting tool above for melters and tanks. Most “won’t melt / won’t flow” reports trace to setpoints, sensors or a cold downstream path - not a dead tank.

01

Slow Heat-Up

Confirm voltage/build, load size and lid closed before assuming a heater fault.

02

Over-Temp / Faults

Follow manual reset and sensor checks for your serial family.

03

No Discharge

Valve, viscosity at temperature and downstream hose heat matter.

04

Still Stuck

Factory path with serial, setpoints and photos.

Process temperature and viscosity

What Viscosity Means Here

If wax will not leave the tank, check temperature at the valve - viscosity wins when the outlet is cooler than the bath.

01

What It Is

Thickness at the temperature you melt, hold, dip, transfer or fill.

02

Why Heat Matters

Heat lowers viscosity so material moves without setting in the path.

03

What We Size

Tank, filler, voltage and hose path around viscosity at operating temperature.

Tools above stay interactiveUSA built since 1999 · BBB A+

Next Step

Run the symptom tool above, then contact support with model and serial if needed.