Aerospace & Defense Thermal Processing Equipment
Industrial thermal-processing systems for composite resins, potting and encapsulation compounds, thermal-interface materials, specialty coatings, waxes, sacrificial materials and other process-sensitive aerospace and defense manufacturing materials.
What the Equipment Must Do
Select the tank and downstream equipment around the material, operating temperature, working volume, hold time and production cadence—not the industry name alone.
Thermal stability
Maintain usable viscosity and repeatable material condition during holding, transfer and dispensing.
Process integration
Coordinate the heated tank with pumps, hoses, valves, filling or dispensing equipment and downstream production.
Material protection
Select the heating approach around the material’s temperature sensitivity, hold time and allowable thermal exposure.
Recovery demand
Account for repeated loading, cold product introduction or production cycles that can pull the process below target temperature.
Which PRIMO System Fits This Process?
Recommended starting point: PRIMO Thermal Conditioning. For aerospace and defense materials, PRIMO Thermal Conditioning is usually the best starting point when stable viscosity, controlled heat input and extended heated holding are critical. Standard PRIMO is appropriate for straightforward melting and heated processing of compatible waxes or solid feedstocks. Rapid-Cycle is appropriate when repeated loading or short recovery time is the production bottleneck.
Melting & Production Holding
Standard PRIMO
Choose for compatible waxes, sacrificial materials and solid feedstocks that primarily need melting and production holding.
View Standard PRIMO Melters →
RECOMMENDED STARTING POINT
Controlled Heating & Extended Holding
PRIMO Thermal Conditioning
Best starting point for resins, potting materials, thermal-interface compounds, coatings and temperature-sensitive formulations that must remain process-ready.
View Thermal Conditioning Systems →
Recovery Speed & Production Throughput
PRIMO Rapid-Cycle
Choose when repeated loads, immersion cycles or frequent batch turnover require faster recovery between production cycles.
View Rapid-Cycle Melters →
Typical Thermal-Process Workflow
- 01
Condition or melt the material to its validated process range.
- 02
Maintain temperature through transfer and dispensing.
- 03
Use dedicated wax-removal or recovery equipment when the process is removal rather than application.
Have WaxMelters Review the Application
Send the material, starting and target temperatures, working volume, hold time, batch frequency, downstream process and available electrical service. For regulated or sanitary processes, also include required surface finish, fittings, cleaning method and facility standards.
Request an Application Review
Calculate PRIMO Savings
Compare PRIMO Systems
