Industrial Dispensing, Filling & Heated Transfer Systems
Move temperature-controlled waxes, oils and compatible process
materials from a melting or holding tank to containers, another
vessel or the next production step.
Select the equipment path according to whether you need
operator-controlled dispensing, measured automated filling,
multiple simultaneous fills, heated material transfer, or a
complete melting and filling system.
Flexible Dispensing
Semi-Automatic Single-Head Dispensing
Operator-controlled heated dispensing for varied
containers, frequent product changes and flexible
production requirements.
Move temperature-controlled material from one vessel
to another tank, production area or downstream process
when measured container filling is not the primary job.
EZ-T dedicated heated transfer systems
Heated pumping and hose assemblies
Tank-to-tank transfer
Tank-to-process transfer
Material movement between production stages
Optional transfer capability on compatible filling systems
Start with what happens after the material leaves the
tank. Tell us whether you need to fill containers,
transfer material to another location, or perform both
functions with the same system.
Filling and transfer equipment should be selected around
the complete material path and production requirement, not
simply the pump or nozzle.
Material
Viscosity, operating temperature, additives and material
behavior affect pump, hose and discharge requirements.
Fill or Transfer
Measured container filling, operator-controlled
dispensing and continuous material transfer have
different operating priorities.
Source Tank
The source vessel and outlet must provide enough
temperature-controlled material for the intended
filling or transfer rate.
Production Workflow
Fill sizes, transfer distance, throughput, changeovers,
labor, staging and downstream handling determine the
useful equipment configuration.
The source tank, pump, heated hose and discharge
equipment operate together as a thermal material-handling
system. The correct configuration depends on the material,
temperature, flow requirements and what must happen at
the discharge point.
Filling and Transfer Can Be Combined
Compatible EZ-1, AutoShot and Pour X-Press systems
can be configured so the heated pumping system can
support normal filling operations and continuous
material transfer when the production process
requires both functions.
Application & Sizing Support
Tell Us What You Need to Fill, Dispense or Transfer
Provide the material, operating temperature, fill or transfer
requirements, desired output, existing tank information and
whether the same system needs to perform both filling and
heated transfer.
Which Dispensing, Filling or Transfer System Fits Your Production?
Start with the job you need to accomplish, then configure the equipment around your
material, container size, temperature and production requirements. Systems range from
flexible operator-controlled dispensing to automated multi-head filling and complete
PRIMO melting + filling platforms.
For moving heated material rather than measuring individual container fills.
Heated Material Movement
EZ-T
Dedicated Heated Transfer System
BEST FOR: Tank-to-tank, tank-to-process and production-area
transfer where moving material is the primary requirement.
Choose Your Transfer Configuration
Transfer systems available in configurations up to approximately
1, 3, 5 or 10 gallons per minute depending on application.
Dedicated heated pumping system
Heated hose and portable discharge point
Tank-to-tank material movement
Tank-to-process transfer
Connects to compatible existing equipment
Choose EZ-T when: transfer is the main job. If container
filling is the primary job and transfer is only occasional, consider adding
transfer capability to a compatible filling system instead.
Choose the System Around Your Process, Not Just the Model Number
Compare your material, operating temperature, smallest and largest fill,
desired production rate, existing tank, transfer distance and future
production growth before choosing equipment.
